iPhone 5

Solve Your iPhone 5 Touch Screen Problems by Yourself?

 

One of the common problems that your iPhone 5 can occur is the touch screen problem. These Smart phones (especially iPhone) is entirely based upon Touch, and you cannot perform any function (or even operate) your iPhone without this feature. So try to solve your problems by Yourself.

In the following lines you will get to know about some of the basic iPhone 5 touch screen problems as well as their solutions.

Problems

• Touch not responding.
• Slow Response.

Causes of Problems

• Touch screen might be physically damaged.
• Water damage on touch screen.
• LCD screen is broken. However it is not important that touch stops responding after LCD is broken.
• Dust or dirt over touch screen on-board connector or strip connector.
• Dry soldering of iPhone 5 touch screen connector.
• Primary or secondary touch control IC might be faulty.

What You’ve to Do?

To solve ypur iPhone 5 touch screen problem:

• Restart your iPhone 5 and Check.
• Factory Reset your phone (Make sure to Backup your data)

Hardware Solution

Here is the hardware solution of iPhone 5 touch screen problem:

• Unplug and plug touch screen strip carefully  and check.
• Plug-in any other good LCD Screen and Check. This step is to verify whether the problem is in hardware or iPhone 5 LCD is faulty.

• If the problem is in hardware then clean touch on board connector and check, dust may be the cause of touch screen problem.
• Gently heat surrounding components of touch screen and check.
• Re-solder each pin of touch connector and check.
• Now gently heat Primary as well as Secondary Touch Controller IC and check.
• If everything else fails then change Primary Touch Controller IC.

All these steps will surely help you to solve iPhone 5 touch screen problem. Most of the time the problem arises due to LCD screen, but in a number of cases a simple restart or cleaning the connectors may help to solve the problem. The best thing about this is that the procedure isn’t that difficult, and if you have some soldering experience then you can get this thing done all by yourself, without the need of going to any repair center.

Enjoy!!!